The Upholstery Forum

There you go make me a frame and cushion that might fit this.

Just saying you got to love it when people do this.

And they don't want the cover remade?

Curious how you're going to do this. I have a set of covers made for my boat but I don't have any of the seat bottoms. I was going to use the covers as patterns but am wondering if you add or subtract anything to make sure it fits right, then there's the foam too. I do know the covers are correct as they were sewn by the same two women who made them for the boat manufacturer years ago, they have the original patterns.

Well. I have done a few. I know the foam is about an 1/8 inch larger than frame. Using the pattern as an example. If I get it a little smaller than it actually was. I’ll be fine. Getting it to big and it not fitting back in the boat , not good. I know it’s a 1994.

Happy that was your project and and not mine. You did well.

I hope I don’t have many of those. They brought the back part later. It was fiberglass. Still had to replace wood on the ends. Replace the staple strips on the back. I had to heat the fiberglass up to get it to take a staple. I guess there is a trick to that.

nice job!

Well done