The Upholstery Forum

Hello. I've been asked by my fitness center to reupholster a couple pieces of fitness equipment padding. The ends of the padding are stapled to a thin wooden ring. The dimensions of the ring is 3.25" diameter, the hole opening is 2" diameter, the width of the ring 5/8" (maybe 1/2") and the thickness is 1/8".

Below are images of the fitness equipment padding, the wooden rings and how they are used:






Does anyone know where I can get these rings?

Thank you.

Hole saw should be okay for those. 3 1/4" may be hard to find. 3 1/2" should be easy enough to sand to 3 1/4. 2" would be no problem. The ring is 5/8" for sure.
Hope that helps.

Thank you very much!