The Upholstery Forum

I've been doing canvas work for a couple of years now and I am getting requests for boat cushions and seats now.
The 1st set I have has piping on edges and in the middle. Not the one I wanted to start with but hopefully it isnt a disaster.

Anyway when it comes to upholstery work what are your go to presser feet?

Thanks

For boats I suggest smooth bottom flat feet and welt feet sizes 3/16 and 1/4. Its good to have both to adjust for welt size and material thickness. I also have zipper feet but dont use them often. I normally sew zippers with flat feet

Thanks @John
I use flat feet for zippers as well.

John wrote: ↑Sat May 09, 2020 8:48 pm For boats I suggest smooth bottom flat feet and welt feet sizes 3/16 and 1/4. Its good to have both to adjust for welt size and material thickness. I also have zipper feet but dont use them often. I normally sew zippers with flat feet

Hey @John any suggestions where to buy, what brand is best? Amazon has a ton and I don't want to buy junk.

Thanks again

What machine are you using again?

@miket ,

I think for genuine parts go to www.singeronline.com

I have the 3/16 and 1/4 " zipper foot and got them from a supplier that probably has them in stock. @John I am very tempted to get a top stitch foot . What do you think of those?

@John consew 206 rb5

Thanks @BigRig

@miket ,

I say buy the genuine parts if you plan on sewing much otherwise the softer steel is ok.

https://www.goldstartool.com/10796k-107 ... ot-set.htm

The 2nd one, 10796K. Is this all I need for piping or there others I should get also?

I prefer this style welt feet. http://atlaslevy.com/S32-Piping-Welting ... p_226.html

Usually if you purchase from a reputable dealer the feet are good. I am cautions about purchasing them on amazon and ebay.